How To Set Up the PartyCam Mini….

Before installing the ipad mini, turn on the guest director light with the little switch on the small internal case

Install the ipad by fitting into the tabs at the top of the mount

Swing the ipad down and carefully pull back on the bottom tab so the ipad snaps in place . This is a VERY tight fit, and the bottom tab is short. It may seem like it does not fit, but it will! Use only as much pressure as you need to pull the tab back and snap it in place.

 Once snapped in place, ensure the ipad is moved to the far left as viewed from the back

Open the case buy flipping out the kodak emblem and using it as a pull, and push down on the silver button

Watch this video to see the steps to open and close the camera

Install the Lightpad into the slot

Connect the white connectors together which hooks the switch to the lightpad

When you disconnect, make sure to pull only on the connector, not the wires. It is a very tight fit, you will need to wiggle it apart

When you are adjusting the settings on the light pad, to have it “remember” your settings push down on the button and hold it for at least 20 seconds. That way the light pad will remember the last setting you had when you turn it off and on with the switch on the handle

All set! Have some fun and make some $$$